Bob Vine
  • Home
  • Film Projects
  • Contact
  • Gallery
  • Blog
  • SuppsApp

Typhoon H cable cam tests

10/22/2016

0 Comments

 
Have worked a drone shot into my next film called 'Retirement' which involves a wide reveal type shot of my mother's house. It is just a simple flyover the top of her house to reveal the front.

However, never used the cable cam mode before which would allow me to control the camera while it flies automatically between two points. Set up the two points okay. But found I couldn't control the camera. Points I've subsequently learnt:

1. Position the camera before you set the waypoint
2. Put the Gimble into Gimble mode (right camera switch to the down position) - this allows the right controller to move camera if needs be.
3. Once the H is at waypoint 1 after swiping start, push the left controller up slowly to get a slow fly between points - watch the points go from point 1 to point 2
4. Control camera

Overall, give yourself a bit a a run up and set the end waypoint a little further than you need.

If the camera doesn't connect straight away - tap into settings then camera and select the pro camera again.

Check the camera settings before take off - size, manual WB and manual ISO - low as possible then adjust shutter speed - give it time to adjust. Then check exposure again at way points.

Should be fine!
0 Comments



Leave a Reply.

    Archives

    October 2016
    September 2016
    January 2016
    December 2015
    March 2015
    March 2014
    January 2014
    December 2013
    November 2013
    October 2013
    September 2013
    July 2013
    June 2013
    May 2013
    April 2013
    March 2013
    February 2013
    January 2013
    December 2012
    November 2012
    September 2012
    August 2012
    July 2012
    June 2012
    May 2012
    April 2012

    Categories

    All

    RSS Feed

Powered by Create your own unique website with customizable templates.